Cat and Dog Repellent Circuit Diagram

Sunday, 30 June 2013

Cat and Dog Repellent Circuit Diagram

 


The electronic dog repellent circuit diagram below is a high output ultrasonic transmitter which is primarily intended to act as a dog and cat repellent. The ultrasonic dog repellant uses a standard 555 timer IC1 set up as an oscillator using a single RC network to give a 40 kHz square wave with equal mark/space ratio. This frequency is above the hearing threshold for humans but is known to be irritating frequency for dog and cats.

Cat and Dog Repellent Circuit Diagram
Since the maximum current that a 555 timer can supply is 200mA an amplifier stage was required so a high-power H-bridge network was devised, formed by 4 transistors TR1 to TR4. A second timer IC2 forms a buffer amplifier that feeds one input of the H-bridge driver, with an inverted waveform to that of IC1 output being fed to the opposite input of the H-bridge which can be seen at A & B in an oscilloscope.
Get more information on various electrical projects, embedded projects, electronics projects, communication projects by visiting this blog regularly.

No comments:

Post a Comment