Auto Switching Light  

                                       

  Here is a useful home circuit for you. This automatic lighting system can be installed in your home to light the premises using CFL or Fluorescent lamp. The lamp automatically turns on around 6 pm and turns off in the morning. So this switchless circuit is highly useful to light the premises of the house even if the inmates are not in home. Generally the LDR based automatic lights flicker when the light intensity changes at dawn or dusk. So CFL cannot be used in such circuits. In Triac controlled automatic lights, only the incandescent bulb is possible since the flickering may damage the circuit inside the CFL. This circuit overcomes all such drawbacks and instantly turns on/off when the preset light level changes.

How it works?

IC1 (NE555) is the popular timer IC which is used in the circuit as a Schmitt trigger to get a bistable action. The set and reset activities of the IC is used to switch on/off the lamp. Inside the IC there are two comparators. The upper threshold comparator trips at 2/3 Vcc while the lower trigger comparator trips at 1/3 Vcc. The inputs of these two comparators are tied together and connected at the junction of the LDR and VR1. Thus the voltage provided by the LDR to the inputs depends on the intensity of light.

LDR is a kind of variable resistor and its resistance varies depending on the intensity of light falling on it. In dark, LDR offers very high resistance as high as 10 Meg Ohm but it reduces to 100 Ohms or less in bright light. So LDR is an ideal light sensor for automatic lighting systems.

During day time, the LDR has less resistance and current flows through it to the threshold (Pin6) and the trigger (pin2) inputs of IC. As a result, the voltage at the threshold input goes above 2/3 Vcc which resets the internal Flip-Flop and the output remains low. At the same time, the trigger input gets more than 1/3Vcc. Both the conditions keep the output of IC1 low during day time. The relay driver transistor is connected to the output of IC1 so that, the Relay remains de energized during day time.

At sunset, the resistance of LDR increases and the amount of current flowing through it ceases. As a result of this , the voltage at the threshold comparator input (pin6) drops below 2/3Vcc and the voltage at the trigger comparator input (pin2) less than 1/3Vcc. Both these conditions cause the output of the comparators to go high which sets the Flip-Flop. This changes the output of IC1 to high state and T1 triggers. LED indicates the high output of IC1. When T1 conducts, relay energize and completes the lamp circuit through the Common (Comm) and the NO (Normally Open) contacts of the Relay. This state continues till morning and the IC resets when the LDR exposes to light again.

Capacitor C3 is added to the base of T1 for the clean switching of the relay. Diode D3 protects T1 from back e.m.f when T1 switches off.

How to set?

Assemble the circuit on a common PCB and enclose in a shock proof case. A plug in type adapter box is a good choice to enclose the transformer and the circuit. Place the unit where sunlight is available during day time preferably outside the home. Before connecting the relay, check the output using the LED indicator. Adjust VR1 to turn on the LED at a particular light level, say at 6 pm. If it is ok, then connect Relay and the AC connections. The phase and neutral can be tapped from the primary of the transformer. Take the phase and neutral wires and connect to a bulb holder. You can use any number of lamps depending on the current rating of the relay contacts. Light from the lamp should not fall on the LDR so position the lamp accordingly.

Caution: There is 230 Volts in the relay contacts when charged. So do not touch the circuit when it is connected to mains. Use good sleeving for the relay contacts to avoid shock.